소개

Replace an aging power cord on the TRS-80 Color Computer.

부품

부품은 필요하지 않습니다.

Flip the computer over.
  • Flip the computer over.

  • Remove the two 24.1mm Phillips screws near the front of the case.

  • Remove the five 33.0 mm Phillips screws towards the back of the case.

댓글 쓰기

Carefully flip the computer right side up. Lift off the top half of the case.
  • Carefully flip the computer right side up.

  • Lift off the top half of the case.

댓글 쓰기

Near the motherboard, gently pull the keyboard ribbon cable until it becomes free. Lift the keyboard out of the case.
  • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

  • Lift the keyboard out of the case.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Remove the nine 15.24 mm Phillips screws securing the motherboard in place. When removing the spring door, make sure to keep the door closed. When removing the spring door, make sure to keep the door closed.
  • Remove the nine 15.24 mm Phillips screws securing the motherboard in place.

  • When removing the spring door, make sure to keep the door closed.

댓글 쓰기

Remove the 5 jumper cables from the motherboard. Once the jumper cables lift the motherboard up gently; it should lift out easily. Once the jumper cables lift the motherboard up gently; it should lift out easily.
  • Remove the 5 jumper cables from the motherboard.

  • Once the jumper cables lift the motherboard up gently; it should lift out easily.

댓글 쓰기

Remove the two 1.6 inch screws securing the transformer. Remove the two 1.6 inch screws securing the transformer.
  • Remove the two 1.6 inch screws securing the transformer.

댓글 쓰기

Remove the power cord's three leads from the transformer.
  • Remove the power cord's three leads from the transformer.

  • Note the orientation and color of the three leads. Make sure to replace these exactely as they were.

댓글 쓰기

Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out. Remove the entire length of cord from the case and replace with a new one.
  • Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out.

  • Remove the entire length of cord from the case and replace with a new one.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

Christopher Paige

회원 가입일: 2011년 01월 21일

495 평판

안내서 3개 작성하였습니다

Cal Poly, Team 11-24, Maness Winter 2011 Cal Poly, Team 11-24, Maness Winter 2011 회원

CPSU-MANESS-W11S11G24

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 6

전체 시간: 1,699