주요 콘텐츠로 건너뛰기

Teenage Engineering OP-Z Rubber Feet Replacement

필요한 것

  1. Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 1 단계, 이미지 1/3 Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 1 단계, 이미지 2/3 Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 1 단계, 이미지 3/3
    • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

    • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

  2. Teenage Engineering OP-Z Rubber Feet Replacement: 2 단계, 이미지 1/2 Teenage Engineering OP-Z Rubber Feet Replacement: 2 단계, 이미지 2/2
    • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

    • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

  3. Teenage Engineering OP-Z Rubber Feet Replacement: 3 단계, 이미지 1/1
    • Remove the bottom plate including the rubber feet.

  4. Teenage Engineering OP-Z Rubber Feet Replacement, Rubber Feet: 4 단계, 이미지 1/1
    • Remove the four Phillips #0 screws from the back of the rubber feet.

  5. Teenage Engineering OP-Z Rubber Feet Replacement: 5 단계, 이미지 1/2 Teenage Engineering OP-Z Rubber Feet Replacement: 5 단계, 이미지 2/2
    • Separate the front and rear part of the rubber feet from the back cover.

  6. Teenage Engineering OP-Z Rubber Feet Replacement: 6 단계, 이미지 1/1
    • When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

결론

To reassemble your device, follow these instructions in reverse order.

Tobias Isakeit

회원 가입일: 03/31/14

117,296 평판

안내서 188개 작성하였습니다

Master Techs Master Techs 회원

Community

322 회원들

안내서 2,521개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 4

30일 전: 25

전체 시간: 1,583