부품

부품은 필요하지 않습니다.

  1. Power down the TiVo and detach the power cable from the rear of the unit.
    • Power down the TiVo and detach the power cable from the rear of the unit.

      • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

    댓글 쓰기

  2. Remove the five T10 screws from the rear of the case using the Torx screwdriver.
    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

    댓글 쓰기

    • Lift up and pull back the outer casing towards the rear of the unit.

    I have the TiVo Series 2 model TCD746500 and the procedure for replacing a fan on my model is almost identical to the procedure described here, with one significant difference at this step: first pull/slide the outer casing back towards yourself and only thereafter pull it up.

    Oscar Abraham Jaeger - 답글

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Disconnect the power to the hard drive.

    댓글 쓰기

    • Grab the hard drive data cable from both sides of the connector and unplug it from the hard drive.

      • Use extreme caution when unplugging connector and do not disconnect the data cable by pulling on the cable itself.

    댓글 쓰기

    • Unscrew the two screws on the case of the hard drive with a T10 screwdriver.

    • Pull the hard drive up and out of the TiVo unit.

    댓글 쓰기

    • Unscrew the four screws, shown in the picture, with a T-10 screwdriver.

    • Remove the hard drive from the case.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Svyatoslav Markeyev

회원 가입일: 2010년 04월 16일

135 평판

안내서 5개 작성하였습니다

Cal Poly, Team 33-79, Johann Spring 2010 Cal Poly, Team 33-79, Johann Spring 2010 회원

CPSU-JOHANN-S10S33G79

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 2

지난 30일: 11

전체 시간: 6,834