소개

If you find that your DVD player is overheating, use this guide to remove and replace the fan.

부품

부품은 필요하지 않습니다.

  1. Remove the three 6mm Phillips head screws on the back of the DVD player with a Phillips #1 screwdriver.
    • Remove the three 6mm Phillips head screws on the back of the DVD player with a Phillips #1 screwdriver.

  2. Remove the two 3mm Phillips screws on each side of the DVD player using the Phillips #1 screwdriver. Remove the two 3mm Phillips screws on each side of the DVD player using the Phillips #1 screwdriver.
    • Remove the two 3mm Phillips screws on each side of the DVD player using the Phillips #1 screwdriver.

  3. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  4. Using your hand, gently lift the black top panel and safely place it off to the side.
    • Using your hand, gently lift the black top panel and safely place it off to the side.

  5. The fan will be attached to the case, connected to the yellow circuit board.
    • The fan will be attached to the case, connected to the yellow circuit board.

  6. Remove the two 7mm Phillips head screws attaching the fan to the case of the DVD player. Remove the two 7mm Phillips head screws attaching the fan to the case of the DVD player.
    • Remove the two 7mm Phillips head screws attaching the fan to the case of the DVD player.

  7. Use your fingers to unplug the red and black wire from the yellow circuit board to completely remove the fan. Use your fingers to unplug the red and black wire from the yellow circuit board to completely remove the fan.
    • Use your fingers to unplug the red and black wire from the yellow circuit board to completely remove the fan.

결론

To reassemble your device, follow these instructions in reverse order.

Nouriyah Saleh

회원 가입일: 2018년 10월 22일

749 평판

안내서 6개 작성하였습니다

UC Davis, Team S11-G1, Lore Fall 2018 UC Davis, Team S11-G1, Lore Fall 2018 회원

UCD-LORE-F18S11G1

3 회원들

안내서 6개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 43