Skip to main content
  1. Make sure the device is off to prevent data loss. Slide both latches to the unlocked position to release the battery.
    • Make sure the device is off to prevent data loss.

    • Slide both latches to the unlocked position to release the battery.

    • Switch the latch on the right to reveal red. The latch on the left needs to be held.

    • Pull the battery toward you while holding the left latch.

  2. Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.
    • Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.

  3. 아이폰 배터리 수리 키트

    Only $29.99

    Buy Now

    아이폰 배터리 수리 키트

    Only $29.99

    Buy Now
  4. Pull up on the back casing and remove it, revealing the audio/usb port. Pull up on the back casing and remove it, revealing the audio/usb port.
    • Pull up on the back casing and remove it, revealing the audio/usb port.

  5. Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.
    • Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.

  6. Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.
    • Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.

  7. Remove the ribbon cable from the port to free it from the laptop.
    • Remove the ribbon cable from the port to free it from the laptop.

    • Be careful when reconnecting the ribbon cable, it can be difficult.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

JRJones

회원 가입일: 2013년 04월 19일

121 평판

안내서 5개 작성하였습니다

Cal Poly, Team 2-19, Maness Spring 2013 Cal Poly, Team 2-19, Maness Spring 2013 회원

CPSU-MANESS-S13S2G19

3 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 781