주요 콘텐츠로 건너뛰기

소개

Replacing the keyboard is an intermediate level repair. Following the instructions carefully will help you successfully replace your keyboard.

부품

지정된 부품이 없습니다.

  1. Locate the battery locks on the bottom of the laptop. Slide the right lock outwards, until it locks into place. Slide and hold the left lock outwards and hold it in place.
    • Locate the battery locks on the bottom of the laptop.

    • Slide the right lock outwards, until it locks into place.

    • Slide and hold the left lock outwards and hold it in place.

  2. While holding the lock in place, slide the battery out towards you.
    • While holding the lock in place, slide the battery out towards you.

  3. Using a #1 Phillips screwdriver, remove the 5.8 mm screw in the battery slot.
    • Using a #1 Phillips screwdriver, remove the 5.8 mm screw in the battery slot.

  4. Use a plastic opening tool to pry off the plastic panel above the keyboard.
    • Use a plastic opening tool to pry off the plastic panel above the keyboard.

  5. Unscrew the four 3.7 mm screws at the top of the keyboard using a #1 Phillips screwdriver. Unscrew the four 3.7 mm screws at the top of the keyboard using a #1 Phillips screwdriver.
    • Unscrew the four 3.7 mm screws at the top of the keyboard using a #1 Phillips screwdriver.

  6. Slowly lift the keyboard out, up and towards the screen.
    • Slowly lift the keyboard out, up and towards the screen.

    • Do not try to remove the keyboard completely because it is still attached to the motherboard.

  7. Using a plastic opening tool, flip the ZIF connector up to release the ribbon and the keyboard.
    • Using a plastic opening tool, flip the ZIF connector up to release the ribbon and the keyboard.

결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

Jerry Wakai

회원 가입일: 2013년 01월 31일

335 평판

안내서 4개 작성하였습니다

Cal Poly, Team 7-7, Maness Winter 2013 Cal Poly, Team 7-7, Maness Winter 2013 회원

CPSU-MANESS-W13S7G7

5 회원들

안내서 6개 작성하였습니다

Nice little guide. The only thing I can really think to add would be on the last part for those of us who are super-paranoid about breaking something. If you could add a picture of what the ZIF connector looks like after it's opened would help some.

I appreciate the guide, thanks. :)

Christopher Tidwell - 답글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 12

전체 시간: 4,280