주요 콘텐츠로 건너뛰기

소개

A guide to replace the SUB/SD card/headphone jack within your Toshiba Radius.

부품

지정된 부품이 없습니다.

  1. Turn off the laptop before starting.
    • Turn off the laptop before starting.

    • Remove the two rubber feet closest to the hinge with a plastic opening tool.

  2. Remove the twelve M2x4mm PH0 Philips head screws.
    • Remove the twelve M2x4mm PH0 Philips head screws.

  3. Loosen the back cover with a plastic opening tool.
    • Loosen the back cover with a plastic opening tool.

    • The least damaging way to pry the cover is to start from a corner and run the spudger along the edge.

    • Do not crack or bend the cover.

  4. Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  5. Carefully lift open the cover.
    • Carefully lift open the cover.

    • Remove the attached purple ribbon cable underneath the cover.

    • Do not rip the ribbon cable.

  6. Unscrew the two screws holding the panel of the UBS/SD card/headphone jack
    • Unscrew the two screws holding the panel of the UBS/SD card/headphone jack

  7. disconnect the cable shown from the motherboard
    • disconnect the cable shown from the motherboard

  8. disconnect the cable attached to the top of the USB/SD card/headphone jack interface
    • disconnect the cable attached to the top of the USB/SD card/headphone jack interface

  9. remove the interface
    • remove the interface

결론

To reassemble your device, follow these instructions in reverse order.

Garrett barta

회원 가입일: 2017년 09월 20일

101 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 169