Trek 800 Mountain Track 1994 Front Brakes Replacement

소개

In this guide, you will learn how to replace the front brakes on your Trek 800 Mountain Track 1994 Bicycle. You will need a pair of new brake pads, sandpaper, brake oil, an adjustable wrench, and an Allen wrench.

필요한 것

1 단계 Front Brakes

Trek 800 Mountain Track 1994 Front Brakes Replacement, Front Brakes: 1 단계, 이미지 1/1

Check if your brake pads are worn down. If they are less than ¼ of an inch thick, it is time to replace them.

번역하기

2 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 2 단계, 이미지 3/3

First, unscrew the pinch bolt on the left front brake using an adjustable wrench.

번역하기

3 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 3 단계, 이미지 3/3

Unhook the brake cables from both sides.

번역하기

4 단계

Starting with the right brake pad, unscrew the bolt seen in the left side of the brake caliper using an adjustable wrench.

번역하기

5 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 5 단계, 이미지 3/3

Take out the brake pad and the bolt that held it in.
Make sure to save this bolt assembly.

번역하기

6 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 6 단계, 이미지 3/3

Make sure the new brake pad says "R front".
Unscrew the bottom nut of the new brake pad using an Allen wrench.
Slide the bolt assembly that was saved onto the new brake pad.
Screw the nut back on using an Allen wrench.

번역하기

7 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 7 단계, 이미지 3/3

Put the new brake pad back into the holder located near the wheel and screw the bolt on the left side using an adjustable wrench.
Also, tighten the bottom nut of the new brake pad using an Allen wrench.

번역하기

8 단계

Make sure the brake pad is parallel to the tire. This will ensure that the brake pad hits the wheel correctly.

번역하기

9 단계

Hook the brake cable back in on the right side.

번역하기

10 단계

Trek 800 Mountain Track 1994 Front Brakes Replacement: 10 단계, 이미지 3/3

Repeat steps 4-9 on the left side: unscrew the bolt to take out the old brake pad, put the new brake pad back on to the holder near the bike wheel, and screw everything back into place.
Use an adjustable wrench and Allen wrench as described before.

번역하기