주요 콘텐츠로 건너뛰기

소개

If one of the cameras on your device is broken, cracked, or damaged in any way, the following guide will show you how to replace the camera.

부품

지정된 부품이 없습니다.

  1. Begin by flipping the watch over with its back facing upwards. Begin by flipping the watch over with its back facing upwards.
    • Begin by flipping the watch over with its back facing upwards.

  2. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.
    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

  3. Gently lift the backplate up to remove it. Gently lift the backplate up to remove it.
    • Gently lift the backplate up to remove it.

  4. 안드로이드 수리 키트

    A new screen or battery is one kit away.

    지금 장보기

    안드로이드 수리 키트

    A new screen or battery is one kit away.

    지금 장보기
  5. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board.
    • After removing the backplate, lift the master switch up from the circuit board.

  6. Using a Phillips #00 screwdriver,  remove the 0.6 mm screw.
    • Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

  7. Carefully remove the speaker from the case without disconnecting it from the motherboard. Carefully remove the speaker from the case without disconnecting it from the motherboard.
    • Carefully remove the speaker from the case without disconnecting it from the motherboard.

  8. Using the tweezers, carefully lift the bar holding the connection to the screen. Remove the motherboard from the device.
    • Using the tweezers, carefully lift the bar holding the connection to the screen.

    • Remove the motherboard from the device.

  9. Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place. Carefully lift the clips and slide the cameras out.
    • Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place.

    • Carefully lift the clips and slide the cameras out.

결론

To reassemble your device, follow these instructions in reverse order.

Nathaniel Cady

회원 가입일: 2018년 10월 26일

94 평판

안내서 1개 작성함

UMass Dartmouth, Team S3-G5, Peak Fall 2018 UMass Dartmouth, Team S3-G5, Peak Fall 2018 회원

UMASSD-PEAK-F18S3G5

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 3

지난 30일: 9

전체 시간: 118