기기를 수리하세요 커뮤니티 상점

Verizon Ellipsis 10 Camera Replacement

소개

This guide is designed to provide you with simple steps to remove and replace the Verizon Ellipsis 10 Camera.

필요한 것

  1. Verizon Ellipsis 10 Camera Replacement, Back Cover: 1 단계, 이미지 1/1

    • Open the SD/SIM card cover to start prying off the back cover.

    편집

  2. Verizon Ellipsis 10 Camera Replacement: 2 단계, 이미지 1/1

    • Start using the iFixit Opening Tool in the SD/SIM area to release the clips holding the back panel on.

    편집

  3. Verizon Ellipsis 10 Camera Replacement: 3 단계, 이미지 1/1

    • Follow along the edge of the device to undo all of the retaining clips.

    편집

  4. Verizon Ellipsis 10 Camera Replacement: 4 단계, 이미지 1/1

    • Once all the clips are undone, the back panel should come off with little effort.

    편집

  5. Verizon Ellipsis 10 Camera Replacement, Battery: 5 단계, 이미지 1/1

    • Remove the bottom piece of tape securing the battery making sure you are not peeling up anything else in the process.

    편집

  6. Verizon Ellipsis 10 Camera Replacement: 6 단계, 이미지 1/1

    • Remove the top piece of tape using an iFixit opening tool.

    편집

  8. Verizon Ellipsis 10 Camera Replacement: 7 단계, 이미지 1/1

    • Once you have a hold on the tape, carefully remove it making sure you aren’t damaging the battery in the process.

    편집

  9. Verizon Ellipsis 10 Camera Replacement: 8 단계, 이미지 1/1

    • Unplug the battery power connector by sliding the white plastic plug down away from the board.

    편집

  10. Verizon Ellipsis 10 Camera Replacement: 9 단계, 이미지 1/1

    • The battery should be free to come out of the device. Make sure not to bend or damage the battery.

    편집

  11. Verizon Ellipsis 10 Camera Replacement, Camera: 10 단계, 이미지 1/1

    • Remove 4 M1.5 screws holding in the labeled LTE module.

    편집

  12. Verizon Ellipsis 10 Camera Replacement: 11 단계, 이미지 1/1

    • Use a nylon spudger to pry up the module.

    • It's held in with some clips so there will be a little bit of resistance.

    편집

  13. Verizon Ellipsis 10 Camera Replacement: 12 단계, 이미지 1/2 Verizon Ellipsis 10 Camera Replacement: 12 단계, 이미지 2/2

    • Remove the 4 M1.5 screws holding in the labeled auxiliary LTE/GPS module.

    • The module should come up with a little resistance.

    편집

  14. Verizon Ellipsis 10 Camera Replacement: 13 단계, 이미지 1/1

    • Use a pair of tweezers to lift up the front camera off its locating post.

    편집

  15. Verizon Ellipsis 10 Camera Replacement: 14 단계, 이미지 1/2 Verizon Ellipsis 10 Camera Replacement: 14 단계, 이미지 2/2

    • Remove the non-conductive tape covering the camera ribbon cable.

    • You may need to remove the white antenna cable to remove the tape.

    편집

  16. Verizon Ellipsis 10 Camera Replacement: 15 단계, 이미지 1/1

    • Carefully unplug the ribbon cable from the motherboard.

    편집

  17. Verizon Ellipsis 10 Camera Replacement: 16 단계, 이미지 1/2 Verizon Ellipsis 10 Camera Replacement: 16 단계, 이미지 2/2

    • Peel up the ribbon cable carefully as it is glued to the device.

    • After having peeled up the cable, the cameras should be free to come out of the device.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Mary Duran

회원 가입일: 04/03/19

597 평판

안내서 4개 작성하였습니다

배지: 12

배지 +9개 더

팀

Oregon Institute of Technology, Team S2-G10, Lancaster Spring 2019 Oregon Institute of Technology, Team S2-G10, Lancaster Spring 2019 회원

OIT-LANCASTER-S19S2G10

4 회원들

안내서 7개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 1

전체 시간: 145