주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

This guide demonstrates the proper way to remove the cameras in order to reconnect or replace them. This requires no soldering or screws.

부품

지정된 부품이 없습니다.

  1. Using the large plastic opening tool, start along a side of the device and apply light pressure in the seam between the top and bottom outer covers.
    • Using the large plastic opening tool, start along a side of the device and apply light pressure in the seam between the top and bottom outer covers.

    • Maneuver the smaller plastic opening tool at the spot of the large opening tool and slowly slide along the edge.

    • You should feel each plastic connections begin to loosen.

  2. Move tool around each connection, and continue around the device until all connections have been loosened.
    • Move tool around each connection, and continue around the device until all connections have been loosened.

    • The user risks damaging the connections if tool is slid to fast

  3. Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits

    Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits
  4. Once all connections have been loosened and using a soft surface, place the device onto its screen. Open the casing and lay as shown keeping the speaker wire loose, and the camera component is highlighted in red.
    • Once all connections have been loosened and using a soft surface, place the device onto its screen.

    • Open the casing and lay as shown keeping the speaker wire loose, and the camera component is highlighted in red.

  5. Using hook tweezers, gently separate the glued cameras away from the circuit board. Allow each camera to rest on circuit board while proceeding to the ZIF (zero insertion force) on the circuit board. Avoid touching camera lens with the tweezers.
    • Using hook tweezers, gently separate the glued cameras away from the circuit board.

    • Allow each camera to rest on circuit board while proceeding to the ZIF (zero insertion force) on the circuit board.

    • Avoid touching camera lens with the tweezers.

  6. Maneuver the hook tweezers to flip up the black hinged ZIF connector to disconnect camera module. After ZIF connector is flipped up, the camera module may be removed.
    • Maneuver the hook tweezers to flip up the black hinged ZIF connector to disconnect camera module.

    • After ZIF connector is flipped up, the camera module may be removed.

결론

To reassemble your device, follow these instructions in reverse order.

Aaron

회원 가입일: 2016년 07월 19일

298 평판

안내서 2개 작성하였습니다

University of Memphis, Team 1-1, Kim SU 2016 University of Memphis, Team 1-1, Kim SU 2016 회원

UM-KIM-SU16S1G1

4 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 4

전체 시간: 224