소개

Replacing the WIFI antenna + top-firing speaker on your SmartCast Remote is simple with this step-by-step guide.

부품

부품은 필요하지 않습니다.

  1. Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.
    • Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.

  2. Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.
    • Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.

  3. Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.
    • Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.

  4. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  5. During this step, avoid pulling on the red and black wires as they can be easily damaged. Instead, grab only the plug itself.
    • During this step, avoid pulling on the red and black wires as they can be easily damaged. Instead, grab only the plug itself.

    • Use the tweezers to grab the power plug connected to the red and black wires. Disconnect the plug by pulling the tweezers away from the device.

  6. Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug. Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug. Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug.
    • Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug.

  7. Remove the three 3mm screws holding the WIFI antennae in the device. Use the tweezers to grab and remove the metal plate securing the antennae. Two of the screws are silver, while one is black. Two of the screws are silver, while one is black.
    • Remove the three 3mm screws holding the WIFI antennae in the device. Use the tweezers to grab and remove the metal plate securing the antennae.

    • Two of the screws are silver, while one is black.

  8. Remove the WIFI antennae from the device and replace.
    • Remove the WIFI antennae from the device and replace.

결론

To reassemble your device, follow these instructions in reverse order.

Jordan Adams

회원 가입일: 2018년 10월 04일

445 평판

안내서 4개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 3

전체 시간: 63