Vtech InnoTab 3S Headphone Port Replacement

소개

Headphones do not work when you plug them into the InnoTab? This guide will walk you through replacing the headphone port on your childs Vtech InnoTab 3S.

필요한 것

1 단계 Rear Panel

Vtech InnoTab 3S Headphone Port Replacement, Rear Panel: 1 단계, 이미지 1/3

Vtech InnoTab 3S Headphone Port Replacement, Rear Panel: 1 단계, 이미지 2/3

Vtech InnoTab 3S Headphone Port Replacement, Rear Panel: 1 단계, 이미지 3/3

While holding the battery compartment locks down, slide the two battery doors outwards from the sides of the device.
Remove the batteries from the device.

편집

2 단계

Remove six 7 mm screws from the interior of the battery compartment using a Phillips #1 screwdriver.

편집

3 단계

Vtech InnoTab 3S Headphone Port Replacement: 3 단계, 이미지 3/3

Using a nylon spudger, remove the five caps that hide the screws.
Potential for device damage: Be careful not to scrape the plastic from the device using the spudger.
When removing the caps, hold the spudger vertical to the board to make removal easier. Also try to push in with your spudger pointing towards the bottom of the device.
Remove the five 5 mm Phillips #1 screws from the rear panel of the device.

편집

4 단계

Carefully remove the rear panel from the front panel of the device.
Once the rear panel is removed, you'll be able to see the motherboard and other components within the Vtech InnoTab 3s.

편집

5 단계 Headphone Port

Vtech InnoTab 3S Headphone Port Replacement, Headphone Port: 5 단계, 이미지 1/3

Vtech InnoTab 3S Headphone Port Replacement, Headphone Port: 5 단계, 이미지 2/3

Vtech InnoTab 3S Headphone Port Replacement, Headphone Port: 5 단계, 이미지 3/3

The headphone port is located towards the top left side of the device.
With tweezers remove the headphone port from its slot on the device.
The headphone port is fastened by two plastic poles. For easier removal lift the headphone port perpendicular to the device upwards.
Avoid damaging the plastic poles fastening the headphone port to the device. They are extremely fragile.
Solder the wires securing the headphone port to the device.
Avoid forceful movements when soldering to prevent damage to device components and personal injury.