주요 콘텐츠로 건너뛰기

소개

In this guide you will learn how to replace the chip set in a Wahl Lithium Ion Trimmer.

  1. Expose the inside of the trimmer in order to allow access  to the battery, the electric motor, and the chip set. Refer to the 4th step of the Disassembling of Wahl Lithium Ion Trimmer guide.
    • Expose the inside of the trimmer in order to allow access to the battery, the electric motor, and the chip set. Refer to the 4th step of the Disassembling of Wahl Lithium Ion Trimmer guide.

  2. Remove the motor, battery, and chip set from the plastic casing.
    • Remove the motor, battery, and chip set from the plastic casing.

  3. Remove the white plastic piece and the wires from the chip set. If necessary, cut the wires as close to the chip set as possible so that you can reconnect them to the new chip set.
    • Remove the white plastic piece and the wires from the chip set. If necessary, cut the wires as close to the chip set as possible so that you can reconnect them to the new chip set.

  4. Remove the old chip set and install the new one. Then, connect the wires and white piece to the new chip set.
    • Remove the old chip set and install the new one. Then, connect the wires and white piece to the new chip set.

결론

To reassemble your device, follow these instructions in reverse order.

nathan

회원 가입일: 2013년 10월 22일

1,332 평판

안내서 6개 작성하였습니다

University of Maryland, Team 1-3, Shastany Fall 2013 University of Maryland, Team 1-3, Shastany Fall 2013 회원

UMD-SHASTANY-F13S1G3

3 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 13

전체 시간: 2,764