소개

Use this guide to replace the outer case on your Nintendo Wii U GamePad.

부품

부품은 필요하지 않습니다.

  1. Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
    • Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.

    • Lift up and remove the battery cover.

    댓글 쓰기

  2. With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
    • With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.

    • Pull upwards from the bottom of the battery to release it.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Remove the ten 8.9mm Tri-wing Y1 screws hidden underneath square stickers.

    • Lift up the back plate.

    • The back plate is still connected by a cable to the motherboard.

    how do i replace the whole front and back casing?

    enbodylin - 답글

    • Unplug the connector that connects the back plate to the motherboard.

    • Remove the back plate.

    You don't have to remove just be careful

    Heather Sheppard - 답글

결론

To reassemble your device, follow these instructions in reverse order.

다른 8명이 해당 안내서를 완성하였습니다.

Kim Arre

회원 가입일: 2013년 01월 11일

3,174 평판

안내서 8개 작성하였습니다

iFixit iFixit 회원

Community

111 회원들

안내서 7,304개 작성하였습니다

This is either incomplete or mistitled - it is a currently a back plate replacement guide.

At the conclusion of this how-to/walkthrough, most of the GamePad's hardware is still attached to the front plate, one half of the outer case.

Elijah - 답글

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 12

지난 30일: 72

전체 시간: 9,257