Wolf Gourmet WGBL100S Control Board Replacement

소개

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

필요한 것

1 단계 Control Board

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: 1 단계, 이미지 1/2

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: 1 단계, 이미지 2/2

Flip the base of the blender upside-down.
Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

번역하기

2 단계

Using the metal spudger, pry off one half of each rubber foot.
Note that one side of the foot is glued down; pry off the other side.

번역하기

3 단계

Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
Pull the base off of the blender.

번역하기

4 단계

Pull off the plastic housing.

번역하기

5 단계

Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

번역하기

6 단계

Using pliers, pull off all the connectors on the top.

번역하기

7 단계

Pull or pry off the last connector block, then remove the control board.

번역하기

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 5명과 함께

Cole Gillespie

회원 가입일: 04/19/18

476 평판

안내서 2개 작성하였습니다

배지: 9

배지 +6개 더

팀

Cal Poly, Team S25-G16, Maness Spring 2018 Cal Poly, Team S25-G16, Maness Spring 2018 회원

CPSU-MANESS-S18S25G16

4 회원들

안내서 5개 작성하였습니다

Wolf Gourmet WGBL100S Control Board Replacement

소개

필요한 것

1 단계 Control Board

댓글 쓰기

2 단계

댓글 쓰기

3 단계

댓글 쓰기

4 단계

댓글 쓰기

5 단계

댓글 쓰기

6 단계

댓글 쓰기

7 단계

댓글 쓰기

작성자

Cole Gillespie

팀

Cal Poly, Team S25-G16, Maness Spring 2018 Cal Poly, Team S25-G16, Maness Spring 2018 회원

댓글 0개

댓글 쓰기

해당 안내서 넣기

미리보기