Yamaha APX-6N Guitar Strings Replacement - iFixit 수리 안내서

소개

This guide will teach you how to remove old or damaged strings from a Yamaha APX-6N guitar. It will also teach you how to put the new strings on properly and tie knots at the bridge and head so the strings stay in place.

필요한 것

1 단계 Guitar strings

Yamaha APX-6N Guitar Strings Replacement, Guitar strings: 1 단계, 이미지 1/1

Loosen the guitar strings by turning the tuning pegs counter clockwise.

2 단계

Yamaha APX-6N Guitar Strings Replacement: 2 단계, 이미지 1/1

To avoid injury, assure strings are loosened before cutting.
Once the strings are loose, cut them using the wire cutters.
After strings have been cut, remove them by pulling them out of the tuners and the bottom of the bridge.

3 단계

Yamaha APX-6N Guitar Strings Replacement: 3 단계, 이미지 1/2

Yamaha APX-6N Guitar Strings Replacement: 3 단계, 이미지 2/2

Insert the end of the string through the middle of the bridge until four inches comes through.
Wrap the short end of the string around the long end, making a loop.
Put the short end of the string through the loop around three to four times.
Pull both ends of the string until the knot is tight.

4 단계

Yamaha APX-6N Guitar Strings Replacement: 4 단계, 이미지 1/2

Yamaha APX-6N Guitar Strings Replacement: 4 단계, 이미지 2/2

Insert the end of the string into the hole on the correct tuning peg.
Pull the end over the tuning peg and loop under the string. Then push the end of the string under the loop.
Put the end of the string through the loop and pull both ends until the knot is tight.

5 단계

Yamaha APX-6N Guitar Strings Replacement: 5 단계, 이미지 1/2

Yamaha APX-6N Guitar Strings Replacement: 5 단계, 이미지 2/2

Repeat Step 4 for all other strings. Strings should be placed in the tuning pegs in clockwise order. Refer to string packaging for more details.

6 단계

Yamaha APX-6N Guitar Strings Replacement: 6 단계, 이미지 1/1

Turn the tuning pegs clockwise to tighten each string until the string makes a sound when plucked.
Do not overtighten the strings! Strings may snap and lead to injury.

7 단계

Yamaha APX-6N Guitar Strings Replacement: 7 단계, 이미지 1/1

After all strings have been replaced, tune the guitar to your desired tuning.
Check the headstock and the bridge for any loose string ends.
If necessary, use the wire cutters to snip off excess string.
The ends of the strings are very sharp.

결론

You now have new strings for your guitar!

작성자

다른 기여자 3명과 함께

Benjamin

회원 가입일: 05/10/21

145 평판

안내서 1개 작성함

팀

York University, Team S1-G20, O'Regan Summer 2021 York University, Team S1-G20, O'Regan Summer 2021 회원

YORK-O'REGAN-SU21S1G20

1 회원

안내서 1개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 4

전체 시간: 268