Zebra ZP 450 Power Cord Replacement

소개

If your device fails to power on, it may be time to replace the power cord. Follow these instructions to replace the power cord in the Zebra ZP 450.

Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.
Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.

Using the Phillips #1 screwdriver, remove the single 14 mm screw from the clamp that is holding the power cord.
Remove the power cord from the device.

결론

To reassemble your device, follow these instructions in reverse order.

회원 가입일: 02/15/21

277 평판

안내서 3개 작성하였습니다

CMCSC-EGGLESTON-S21S1G6

2 회원들

안내서 6개 작성하였습니다