1. Turn the device over with its display down.
    • Turn the device over with its display down.

    댓글 쓰기

  2. Remove the battery cover, pressing down on the tabs and sliding.
    • Remove the battery cover, pressing down on the tabs and sliding.

    댓글 쓰기

    • Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.

    댓글 쓰기

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Carefully pry up the top end of the back cover using one finger.

    댓글 쓰기

    • Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.

    댓글 쓰기

    • De-solder the white and black speaker wires from their soldering points.

    • Speaker soldering points are located on the thin section of the blue circuit board, and are marked with “SP+” and “SP-”.

    • Keep in mind which color wire was connected at which terminal.

    댓글 쓰기

    • Remove the damaged speaker from its place at the very bottom of the case, just below the battery input.

    • You will have to break the glue holding the speaker in place before removing it.

    댓글 쓰기

    • Replace the damaged speaker and re-solder to the original solder points.

    • Ensure that the negative wire is soldered to the “SP-” while the positive wire is soldered to the “SP+” point.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Alex

회원 가입일: 2013년 10월 28일

758 평판

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 13

전체 시간: 998