메인 컨텐츠로 가기

iPad 2 CDMA Front Panel Adhesive Strips Replacement 소개글 변경 사항

Adam O'Camb- 에 의해 수정

편집 승인됨 에 의해 Adam O'Camb

삭제되었습니다
추가되었습니다
변경 사항 없음
Introduction
Replace the adhesive securing the front panel to the rear case of your iPad 2 CDMA. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] Throughout this procedure, it is recommended to peel up each adhesive strip as needed. [ … ] Parts of this guide were shot with a Wi-Fi model and as such the internals may look slightly different from the LTE model. The procedure is the same for both models except where noted.
Replace the adhesive securing the front panel to the rear case of your iPad 2 CDMA. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] Throughout this procedure, it is recommended to peel up each adhesive strip as needed. [ … ] Parts of this guide were shot with a Wi-Fi model and as such the internals may look slightly different from the LTE model. The procedure is the same for both models except where noted.