메인 컨텐츠로 가기

2000 Jeep Grand Cherokee spark plug replacement 소개글 변경 사항

oldturkey03- 에 의해 수정

편집 승인됨 에 의해 oldturkey03

삭제되었습니다
추가되었습니다
변경 사항 없음
Title
Spark2000 Jeep Grand Cherokee spark plug change
Spark2000 Jeep Grand Cherokee spark plug change
Introduction
vehicle. even Even so it is a high mileage SUV (235,000 miles) miles), junior still uses it as a daily driver. The interval for changing the spark plugs is listed as every 30,000 miles. It is a relatively straight forward task and does only require basic metric hand tools. The spark plugs used for this model are Autolite XP985, pre-gapped at 0.89 mm (.035 in.).
vehicle. even Even so it is a high mileage SUV (235,000 miles) miles), junior still uses it as a daily driver. The interval for changing the spark plugs is listed as every 30,000 miles. It is a relatively straight forward task and does only require basic metric hand tools. The spark plugs used for this model are Autolite XP985, pre-gapped at 0.89 mm (.035 in.).
Conclusion
reverse order. order. Always use a spark plug socket that has a rubber insert to hold the spark plug into the socket. Use the socket and a extesion without a ratchet to had tighten the spark plugs. Ensure that they can be easily screwed into the spark plug hole. There is always a risk of cross threading when using the ratchet. Position ignition coil rubber boots to all spark plugs. Push down on coil assembly until bolt bases have contacted cylinder head. Install 4 coil mounting bolts. Loosely tighten 4 bolts just enough to allow bolt bases to contact cylinder head. Do a final tightening of each bolt in steps down to 29 N·m (250 in. lbs.) torque. Do not apply full torque to any bolt first.
reverse order. order. Always use a spark plug socket that has a rubber insert to hold the spark plug into the socket. Use the socket and a extesion without a ratchet to had tighten the spark plugs. Ensure that they can be easily screwed into the spark plug hole. There is always a risk of cross threading when using the ratchet. Position ignition coil rubber boots to all spark plugs. Push down on coil assembly until bolt bases have contacted cylinder head. Install 4 coil mounting bolts. Loosely tighten 4 bolts just enough to allow bolt bases to contact cylinder head. Do a final tightening of each bolt in steps down to 29 N·m (250 in. lbs.) torque. Do not apply full torque to any bolt first.
Public
아니요

부품

  • Autolite XP985 spark plugs x6 x1 added.
  • Autolite XP985 spark plugs x1 removed.

플래그

  • In Progress removed.