주요 콘텐츠로 건너뛰기

Brother MFC-J4420DW Capacitor Replacement 소개글 변경 사항

Matthias Loikasek- 에 의해 수정

편집 승인됨 완료자 Matthias Loikasek

삭제됨
추가
변경 사항이 없습니다
Introduction
would not react when I pressed pressing the power button. Disconnecting, Disconnecting the power cord, waiting for some seconds and reconnecting resulted in the startup of the printer, but it would immediately shut down with the message that all. all "All functions will be disabled". In the comments of a Youtube video I found a workaround (https://www.youtube.com/watch?v=Gi7cl588J8Q) namely to remove the paper tray before reconnecting the power cord and reinserting it, when it not until the printer asks for it. That workaround does work, did work for, but that is was not a permanent nor a convenient solution. solution. [ ] Since the warranty of the printer was not expired, Brother sent me a technician who replaced a capacitor. After two or three restarts of the printer, on which the printer still misbehaved, the printer started working normally again. [ ] As with all guides, you do that at your own risk. You should know how to solder and be at least a little experienced in disassembling and reassembling things.
would not react when I pressed pressing the power button. Disconnecting, Disconnecting the power cord, waiting for some seconds and reconnecting resulted in the startup of the printer, but it would immediately shut down with the message that all. all "All functions will be disabled". In the comments of a Youtube video I found a workaround (https://www.youtube.com/watch?v=Gi7cl588J8Q) namely to remove the paper tray before reconnecting the power cord and reinserting it, when it not until the printer asks for it. That workaround does work, did work for, but that is was not a permanent nor a convenient solution. solution. [ ] Since the warranty of the printer was not expired, Brother sent me a technician who replaced a capacitor. After two or three restarts of the printer, on which the printer still misbehaved, the printer started working normally again. [ ] As with all guides, you do that at your own risk. You should know how to solder and be at least a little experienced in disassembling and reassembling things.
Time Required Min
30 분
Time Required Max
30 분
Imageid
이전
이후
Difficulty
Moderate
Difficult
Conclusion
To reassemble your device, follow these instructions in reverse order.[ ]
To reassemble your device, follow these instructions in reverse order.[ ]
Public
아니요

도구

  • Portable Soldering Iron x1 added.
  • Wire cutters/side cutters x1 added.
  • Philips Screw Driver x1 added.

부품

  • capacitor 5.5V 0.22F x1 added.

단계

Step #: 1
이전
이후
Step #: 2
이전
이후
Step #: 3
이전
이후
Step #: 4
이전
이후
Step #: 5
이전
이후
Step #: 6
이전
이후
Step #: 7
이전
이후
Step #: 8
이전
이후