#3단계의 변경 사항
편집자 Whitney Lunny-
편집 승인됨 완료자 Whitney Lunny
- 이전
- 이후
- 변경 사항 없음
단계 라인
| - | [* red] Carefully detach the tape from the circuit board, but not the wire as this can damage the wiring. Take both sides of the white cable connector and move it from side to side carefully pulling away from the black terminal until it is removed. |
|---|---|
| - | [* orange] Now take take both sides of the black cable connector and move it from side to side carefully pulling away from the beige terminal until it is removed. |
| - | [* icon_caution] Be sure not to pull on the cables to hard as they are fragile and can be expensive to replace. |
| + | [* red] Detach the tape from the motherboard, but leave it attached to the wire itself to avoid damaging the wire. |
| + | [* red] Pull the white cable connector out of the black terminal by wiggling it gently from side to side with your fingers. |
| + | [* orange] Pull the black cable connector out of the white terminal by wiggling it gently from side to side with your fingers. |
| + | [* icon_caution] Be sure not to pull on the cables too hard as they are fragile and can be expensive to replace. |