메인 콘텐츠로 스킵하기

#9 단계의 변경 사항

Jeff Suovanen- 에 의해 수정

편집 승인됨 에 의해 Jeff Suovanen

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.
[* black] If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.
[* icon_reminder] During reassembly, install the diffuser into the display first, thenmaking sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).
[* icon_reminder] Then,
set the ambient light sensor on top of itthe diffuser. You will need to hold itthe sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.
[* icon_reminder] During reassembly, install the diffuser into the display first, thenmaking sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).
[* icon_reminder] Then,
set the ambient light sensor on top of itthe diffuser. You will need to hold itthe sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.