주요 콘텐츠로 건너뛰기

Fix Your Stuff

Right to Repair

Parts & Tools

#4단계의 변경 사항

Jake Devincenzi- 에 의해 수정

편집 승인됨 완료자 Jake Devincenzi

삭제됨
추가
변경 사항이 없습니다

단계 라인

[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.
[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.