주요 콘텐츠로 건너뛰기

#13단계의 변경 사항

Andrew Optimus Goldheart- 에 의해 수정

편집 승인됨 완료자 Andrew Optimus Goldheart

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.2 mm Phillips screws
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm
[* icon_note] This
screw is different than the 1.6mm screw in step 10, this one is non-magnetic,tends to not be sureattracted to keep track of which 1.6 is whicha magnetized screwdriver. Take care not to avoid interferinglose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.)compass.
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm
[* icon_note] This
screw is different than the 1.6mm screw in step 10, this one is non-magnetic,tends to not be sureattracted to keep track of which 1.6 is whicha magnetized screwdriver. Take care not to avoid interferinglose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.)compass.