주요 콘텐츠로 건너뛰기

#13단계의 변경 사항

dsurati1- 에 의해 수정

편집 거부됨 완료자 Andrew Optimus Goldheart

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.2 mm Phillips screws
[* orange] One 1.6 mm Phillips screw
[* icon_note]icon_caution] TAKE EVERY PRECAUTION TO PLACE THE 1.6 MM PHILLIPS SCREW WHERE IT BELONGS FOR RE-ASSEMBLY OTHERWISE YOU WILL END UP DAMAGING THE LOGIC BOARD!! This screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.
[* icon_note]icon_caution] TAKE EVERY PRECAUTION TO PLACE THE 1.6 MM PHILLIPS SCREW WHERE IT BELONGS FOR RE-ASSEMBLY OTHERWISE YOU WILL END UP DAMAGING THE LOGIC BOARD!! This screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.