주요 콘텐츠로 건너뛰기

#3 단계의 변경 사항

101 Tech USA- 에 의해 수정

편집 승인됨 에 의해 101 Tech USA

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Bearing or bushing are what the axles of the gears fit intointo and there replacement is one of the leading reasons for having to re-shim a gearbox.
[* black] Bearing or bushing are what the axles of the gears fit intointo and there replacement is one of the leading reasons for having to re-shim a gearbox.
[* black] If the round circular piece is made from a soled piece of plastic, brass or steel then it is called a bushing. If the round piece made up of multiple pieces with a spinning middle section then it is a bearing with little round balls on the inside kind of like in a skate board bearing.
[* black] Make sure these bearings are placed properly into gearbox before shimming.
[* black] To place in the gearbox first try to push them in by hand applying even pressure to the bearing/bushing with the wider side facing up. If you need more force to get the bushing in try to use something soft like the back of a rubber screwdriver grip.

이미지 2

이전 이미지가 없습니다

추가