주요 콘텐츠로 건너뛰기

#4 단계의 변경 사항

101 Tech USA- 에 의해 수정

편집 승인됨 에 의해 101 Tech USA

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Once your bushing are in you can finaly get to actual shimming.
[* black] First start with you spur gear (the one that is large round and looks like sounds). Now place it in the center bearing/bushing.
[* black] It most likely dragging on the gearbox wall if this is the case start adding shims to raise it upward just enough that it not dragging on anything when you place the half of the gearbox shell back on.

이미지 1

이전 이미지가 없습니다

추가