주요 콘텐츠로 건너뛰기

#5 단계의 변경 사항

101 Tech USA- 에 의해 수정

편집 승인됨 에 의해 101 Tech USA

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Now you have the spur gear in placeshimmed you get to the sector gear. You find it easier to start with just the sector gear and once you are done and spur back in.
[* black] The sector gear has to be shimmed so that it just clears the cut off leaver but still meshes with the spur gear.You may have adjust the spur gear if possible to meet the needs of the sector gear.
[* black] Just keep using the same test technique and do the final test of screwing down the two shell and anticipating the difference between when the you holding the shells together and when they screwed down tightly.
[* black] Remember too loose is always better than too tight.
[* black] Now you have the spur gear in placeshimmed you get to the sector gear. You find it easier to start with just the sector gear and once you are done and spur back in.
[* black] The sector gear has to be shimmed so that it just clears the cut off leaver but still meshes with the spur gear.You may have adjust the spur gear if possible to meet the needs of the sector gear.
[* black] Just keep using the same test technique and do the final test of screwing down the two shell and anticipating the difference between when the you holding the shells together and when they screwed down tightly.
[* black] Remember too loose is always better than too tight.

이미지 1

이전 이미지가 없습니다

추가

이미지 2

이전 이미지가 없습니다

추가