| - | [* black] Use wrench and slowly tighten the nut until it is about half a turn from touching the wheel. |
|---|
| - | [* icon_note] Be careful not to cross-thread the axle nut. If turns become too difficult, you may need to unthread the nut to straighten it and then proceed with tightening. |
|---|
| + | [* icon_note] Center the second bearing over the where your inserted the spacer and press down until the bearing rests in place. |
|---|
| + | [* black] The bearing's outside edges should be flush with the the inside bottom edge of the wheel |
|---|