Skip to main content

#4 단계의 변경 사항

Andrew Bookholt- 에 의해 수정

승인 대기 중

변경 사항이 없습니다

스텝 라인

[* black] The bottom of the blender. Best place to go if you need your serial number.
[* red] Remove the two Phillips screws (deeply) recessed into the bottom housing.
[* black] Four side tabs hold the plastic bottom in place. Opening the blender is as easy as one, two, three, four.
[* black] The bottom housing is very well ventilated - essential for cooling the 1500 W motor inside.
[* black] This is a super-easy teardown -- for now.