메인 콘텐츠로 스킵하기

#4 단계의 변경 사항

Miroslav Djuric- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] The bottom of the blender. Best place to go if you need your serial number.
[* red] Remove the two Phillips screws (deeply) recessed into the bottom housing.
[* black] Four side tabs hold the plastic bottom housing in place. Opening the blender is as easy as one, two, three, four.
[* black] The bottom housing is very well ventilated --- essential for cooling the 1500W motor housed within.
[* black] This is a super-easy teardown -- for now.
[* black] The bottom housing is very well ventilated --- essential for cooling the 1500W motor housed within.
[* black] This is a super-easy teardown -- for now.