메인 콘텐츠로 스킵하기

#9 단계의 변경 사항

Miroslav Djuric- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Removing the speed sensor.
[* black] Aptly named, the speed sensor monitors the speed of the spinning shaft. Should things get out of hand, the sensor will shut off the motor.
[* black] The speed sensor most likely uses the [link|http://en.wikipedia.org/wiki/Hall_effect|Hall effect] to tell the control circuitry how fast the shaft is spinning.
[* black] Blendtec informed us that the Total Blender includes what they call a "hammer-fire" system. The main IC controller will trigger this system if it detects that the blade stopped spinning. The controller will send a series of strong electric pulses with the intent to free the blades from the obstruction. If that fails, the IC will shut off the motor to prevent any damage.
[* black] The speed sensor most likely uses the [link|http://en.wikipedia.org/wiki/Hall_effect|Hall effect] to tell the control circuitry how fast the shaft is spinning.
[* black] Blendtec informed us that the Total Blender includes what they call a "hammer-fire" system. The main IC controller will trigger this system if it detects that the blade stopped spinning. The controller will send a series of strong electric pulses with the intent to free the blades from the obstruction. If that fails, the IC will shut off the motor to prevent any damage.