주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

#3단계의 변경 사항

Noah- 에 의해 수정

편집 승인됨 완료자 Noah

삭제됨
추가
변경 사항이 없습니다

단계 라인

[* black] Attach synchronizationSet the synchronization device toon the other carburetor.
[* red] Using a flatheadFlathead screw-driver, twist the idle speed screw in to raise the readingflow, and loosenout to lower itit.
[* black] The goal is the meet the two values halfway
[* black] So, if one is higher than the other, lower the high one,
Recheck both carburetors and raise the low on until they meet inadjust as needed to get the middleflow as equal as possible.
[* black] Attach synchronizationSet the synchronization device toon the other carburetor.
[* red] Using a flatheadFlathead screw-driver, twist the idle speed screw in to raise the readingflow, and loosenout to lower itit.
[* black] The goal is the meet the two values halfway
[* black] So, if one is higher than the other, lower the high one,
Recheck both carburetors and raise the low on until they meet inadjust as needed to get the middleflow as equal as possible.

이미지 1

삭제됨