주요 콘텐츠로 건너뛰기

#6 단계의 변경 사항

Louis Squitieri- 에 의해 수정

편집 승인됨 에 의해 Louis Squitieri

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Insert wisdom hereRemove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* black] Pull apart the two sides of the central pillar at the top. They will not separate completely at the bottom.
[* black] With the two halves partially separated, remove the rubber wheel.
[* icon_caution] A small black rectangular piece may fall out of the chute when the halves are separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute
.
[* black] Insert wisdom hereRemove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* black] Pull apart the two sides of the central pillar at the top. They will not separate completely at the bottom.
[* black] With the two halves partially separated, remove the rubber wheel.
[* icon_caution] A small black rectangular piece may fall out of the chute when the halves are separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute
.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

이전 버전

새로운 버전