주요 콘텐츠로 건너뛰기

#6 단계의 변경 사항

Travis Lamb- 에 의해 수정

편집 승인됨 에 의해 Travis Lamb

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* blackred] Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* blackred] Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* black] Pull apart the two sides of the central pillar at the top by using both hands. The two sides will not completely separate at the base.
[* black] With the two halves partially separated, remove the rubber wheel with your hand.
[* icon_caution] A small black rectangular piece may fall out of the chute when the halves are separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute.

이미지 1

이전 버전

새로운 버전