Skip to main content

#2 단계의 변경 사항

Kristen Gismondi- 에 의해 수정

편집 승인됨 에 의해 Kristen Gismondi

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* red] Using the same PH1 Philips screwdriver and bit, unscrewUnscrew the two 10.0 mm screws as shownPhillips #1 screws, and gently pull back the green circuit board.
[* icon_caution] Remove gently,gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.
[* icon_remindericon_note] The button springs may be under compression, don't lose themcompression.
[* red] Using the same PH1 Philips screwdriver and bit, unscrewUnscrew the two 10.0 mm screws as shownPhillips #1 screws, and gently pull back the green circuit board.
[* icon_caution] Remove gently,gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.
[* icon_remindericon_note] The button springs may be under compression, don't lose themcompression.

이미지 1

이전 버전

새로운 버전