주요 콘텐츠로 건너뛰기

#1단계의 변경 사항

Sam Goldheart- 에 의해 수정

편집 승인됨 완료자 Sam Goldheart

이전
이후
변경 사항이 없습니다

단계 라인

-[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of a heat gun to soften the adhesive is highly recommended.
-[* black] With the heat gun set on "low", begin heating the perimeter around the camera bracket.
-[* icon_reminder] It is suggested to heat the desired portion in a circular motion pattern to evenly dissipate the amount of heat throughout the device.
+[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of an iOpener to soften the adhesive is highly recommended.
+[* black] Place the iOpener in the microwave and microwave it for ***one minute*** on the highest power setting.
+ [* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
+[* icon_reminder] Place the iOpener over the front facing camera on the front edge of the top of the display.

이미지 1

이전 버전

새로운 버전