주요 콘텐츠로 건너뛰기

#6단계의 변경 사항

Wouter van der Post- 에 의해 수정

편집 승인됨 완료자 Wouter van der Post

이전
이후
변경 사항이 없습니다

단계 라인

-[* black] Pull the CD-ROM unit out straight up. You can grab the metal edges with you fingers. Some force might be needed, the unit is plugged into the logic board at the bottom of the housing (see
+[* black] The CD-ROM has to be pulled out straight up. Some force might be needed since the unit is plugged into the logic board at the bottom of the housing with a connector board (see the third photo). The board might come out with the CD-ROM unit, or still be connected to the logic board.
+[* yellow] At the left side, it might be possible to use fingers to pull out the unit.
+[* blue] At the right side, a flat head screwdriver can be used. The force that is needed will most likely bend a metal spudger.
+[* black] Once disconnected, flip over the CD-ROM unit and place it next to the housing with the logic board.
+[* violet] The brown cable will still be connected, optionally remove the one Torx screw located next to the cooling fan (see second photo) to disconnect the connector from the housing.
+[* icon_note] When assembling place the connector board on the logic board inside the housing. Push it down until the connector pins are visible at the surface of the connector board.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 이미지 없음

추가

이미지 3

이전 이미지 없음

추가