주요 콘텐츠로 건너뛰기

#6단계의 변경 사항

Wouter van der Post- 에 의해 수정

편집 승인됨 완료자 Wouter van der Post

이전
이후
변경 사항이 없습니다

단계 라인

[* black] The CD-ROM has to be pulled out straight up. Some force might be needed since the unit is plugged into the logic board at the bottom of the housing with a connector board (see the third photo). The board might come out with the CD-ROM unit, or still be connected to the logic board.
[* yellow] At the left side, it might be possible to use fingers to pull out the unit.
[* blue] At the right side, a flat head screwdriver can be used. The force that is needed will most likely bend a metal spudger.
[* black] Once disconnected, flip over the CD-ROM unit and place it next to the housing with the logic board.
[* violet] The brown cable will still be connected, optionally remove the one Torx screw located next to the cooling fan (see second photo) to disconnect the connector from the housing.
-[* icon_note] When assembling place the connector board on the logic board inside the housing. Push it down until the connector pins are visible at the surface of the connector board.