주요 콘텐츠로 건너뛰기

#7단계의 변경 사항

Wouter van der Post- 에 의해 수정

편집 승인됨 완료자 Wouter van der Post

이전
이후
변경 사항이 없습니다

단계 라인

-[* black] Remove the connector board from the CD-ROM unit by placing two fingers on either side of the board and prying it up.
+[* black] If the connector board is still connected to the CD-ROM unit:
+ [* black] Remove the connector board using two fingers on either side of the board and prying it up.
+[* yellow] When assembling, place the connector board on the logic board inside the housing. Push it down until the connector pins are visible at the surface of the connector board.
+[* icon_note] When assembling, make sure the two logic boards (one in the housing and one on the CD-ROM unit) are pushed into the connector board all the way.

이미지 3

이전 이미지 없음

추가