#4단계의 변경 사항
편집자 Benjamin Freeman-
편집 승인됨 완료자 Benjamin Freeman
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [title] Sealing the USB connector |
|---|---|
| + | [* black] Connect the connector to the main board. |
| + | [* black] Reassemble the watch stopping before screwing the lid back. |
| + | [* black] Add hot glue to the base of the USB connector filling the watch case's cavity. Be careful not to put hot glue inside the connector. |
| + | [* black] While the glue is still hot, put the red rubber seal back on top. |
| + | [* black] Screw the lid back. |
이미지 1
이전 이미지 없음
추가