주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

#2단계의 변경 사항

Jeff Suovanen- 에 의해 수정

편집 승인됨 완료자 Jeff Suovanen

삭제됨
추가
변경 사항이 없습니다

단계 라인

[* black] Peel off the small piece of hard plastic stuck to the logic board that stopsDisconnect the camera cable from fallingby sliding it out of its socket. (See detailed image 1).
[* black] Disconnect the camera cable by pulling the male end '''horizontally''' from its socket. (See detailed image 2).

[* icon_note] Make sure to pullicon_caution] Pull the connectorcable parallel to the facesurface of the logic board and towardboard, in the direction of the optical drive.
[* icon_caution]
Do '''not''' pull straight up as thatup, or you will destroy the connector.
[* black] If you see a [https://d3nevzfk7ii3be.cloudfront.net/igi/FdbjNAIY4CP3TQZk.full|small plastic retainer|new_window=true] stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. '''Do not''' attempt to forcibly disconnect the cable with the retainer in place.
[* black] If you still have trouble, use the point of a spudger to push at each side of the connector and [guide|25629|"walk" it slowly from its socket|stepid=64975].
[* black] Peel off the small piece of hard plastic stuck to the logic board that stopsDisconnect the camera cable from fallingby sliding it out of its socket. (See detailed image 1).
[* black] Disconnect the camera cable by pulling the male end '''horizontally''' from its socket. (See detailed image 2).

[* icon_note] Make sure to pullicon_caution] Pull the connectorcable parallel to the facesurface of the logic board and towardboard, in the direction of the optical drive.
[* icon_caution]
Do '''not''' pull straight up as thatup, or you will destroy the connector.
[* black] If you see a [https://d3nevzfk7ii3be.cloudfront.net/igi/FdbjNAIY4CP3TQZk.full|small plastic retainer|new_window=true] stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. '''Do not''' attempt to forcibly disconnect the cable with the retainer in place.
[* black] If you still have trouble, use the point of a spudger to push at each side of the connector and [guide|25629|"walk" it slowly from its socket|stepid=64975].

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

삭제됨