주요 콘텐츠로 건너뛰기

#6단계의 변경 사항

Kyle Mott- 에 의해 수정

편집 승인됨 완료자 Kyle Mott

이전
이후
변경 사항이 없습니다

단계 라인

[* red] Remove the three 6mm screws with a Phillips #00 screwdriver.
+ [* icon_note] Some of the screws may not completely remove from the black housing. A slight tap may jar them loose, but this is not necessary.
[* icon_caution] When re-assembling your drone, be careful not to over tighten the screws. The drone body is made of soft plastic, doing so may strip the screws' housing and prevent them from holding.
-[* icon_note] Some of the screws may not completely remove from the black housing. A slight tap may jar them loose, but this is not necessary.