#6단계의 변경 사항
단계 라인
| - | [* black] Remove the SAS backplane power cable. |
|---|---|
| - | [* black] Remove the data cable from the board. |
| + | [* black] Remove the SAS backplane power cable by pulling the cable out of the board. |
| + | [* black] Remove the data cable from the board using a plastic pry tool to lift the connector out of the socket. |
| [* black] Loosen the 0 Phillips screw holding the backplane in the system. | |
| [* black] To remove the backplane from the chasis. Slide the board down, tilt to a 45 degree angle, and pull the board out. |