주요 콘텐츠로 건너뛰기

#7단계의 변경 사항

Andrew Raposo- 에 의해 수정

편집 승인됨 완료자 Andrew Raposo

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Flip the keyboard over so that you are looking at the keys.
-[* black] To locate the solder joint on the board we can count the number of rows down and keys from the right or left side to our broken key/switch.
-[* black] Then you can use these numbers to count the solder points on the back of the board by flipping it over to find the solder point of the switch in need of replacement.
+[* black] To locate the solder joint on the board count the number of rows down and keys from the right or left side to our broken key/switch.
+[* black] Flip the keyboard over so you can see the solder joints again.
+[* black] Using the number of rows and keys from the left and right count the solder joints which will find the solder joint you need to remove.
[* icon_note] It is helpful to count from the side that has fewer keys until the broken switch so in this case from right to left. So it is on the second row and 5 keys to the left.