주요 콘텐츠로 건너뛰기

#1 단계의 변경 사항

Andrew Bookholt- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black edgeborder around the underside of the front glass panel to the displaydisplay panel.
[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black edgeborder around the underside of the front glass panel to the displaydisplay panel.
[* black] With the heat gun set to low, start by heating the outer edge of the upper right corner of the glass panel.
[* icon_caution] Aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Throughout this process, avoid touching the rubber strip until it is sufficiently cooled.