주요 콘텐츠로 건너뛰기

#1 단계의 변경 사항

Andrew Bookholt- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass display panel.
[* black] With the heat gun set to low, start by heating the outer edge ofblack border near the upper right corner of the glass panel.
[* black] With the heat gun set to low, start by heating the outer edge ofblack border near the upper right corner of the glass panel.
[* icon_caution] Aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Throughout this process, avoid touching the rubber strip until it is sufficiently cooled.
[* icon_note] Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display.