Skip to main content

#9 단계의 변경 사항

Joe Frazier- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] The small black piece that is reattached in the next bullet will not snap into place until the inner back cover is reattached. You will need to hold it in place until then.
[* black] Position the small black piece that fell out in Step 2 against the headphone jack on the side of the phone (circled in Picture 2).
[* icon_note] This piece is very loose and will not snap into place. It must be set into place until the back cover is reattached.
[*
[* black] Replace the inner back cover on the phone.
[* black] Secure the inner cover
phone by screwing in all four T6 screws (circled in Picture 3) with a T6 Torx Screwdriverscrewdriver.
[* icon_note] This piece is very loose and will not snap into place. It must be set into place until the back cover is reattached.
[*
[* black] Replace the inner back cover on the phone.
[* black] Secure the inner cover
phone by screwing in all four T6 screws (circled in Picture 3) with a T6 Torx Screwdriverscrewdriver.

이미지 3

이전 버전

새로운 버전